Litter-Robot 2: Carbon Filter and Seal Strips Installation

The Carbon Filter and gray, brush-type Seal Strips are designed to contain odor within the drawer. The replacement frequency of both accessories is based on personal preference. Order replacement Carbon Filters and Seal Strips from litter-robot.com.

Follow the instructions below to learn how to replace your Carbon Filter and Seal Strips.

Carbon Filter Replacement

To remove:

1. Grab the bottom corner of the filter and pull down, away from the drawer step.

To install:

1. Tuck the top corner under the lip of the drawer.

2. Slide the Carbon Filter upward.

When installed properly, the Carbon Filter should look like the picture below.

Seal Strips Replacement

To remove:

1. Pull up on the old strip and peel off.

2. Use a cotton ball and rubbing alcohol to remove any excess adhesive from the old seal.

3. Make sure the surface is dry before installing new seal strips.

To install:

1. Peel back the protective strip 3-4 inches from the adhesive backing of the seal.

2. Place the adhesive side of the strip above the rib.

3. Press down firmly on the seal strip and peel back the remaining protective backing as you go along.

The seal strip should look like the picture below once the installation is complete.

Purchase Carbon Filters & Seal Strip Kit

Download PDF